Vertex Standardt VXD Series Guía de instalación descargar pdf (Pagina 13)

Page 11

Chapter 2 Mechanical Installation

This section describes the procedures to unpack and mechanically install the VXD-R70 Repeater. A variety

of mounting methods are possible depending on which type of cabinet or rack (if any) has been selected to

house the repeater(s).

Be sure to observe proper electrostatic discharge precautions if modules

must be removed from the repeater.

2.1 Unpacking Equipment

The following items are packed together in the box:

• VXD-R70 Repeater

• AC Line Cord

• VXD-R70 Repeater Installation Guide (This Booklet)

Inspect the equipment for damage immediately after unpacking, and

make a report of the extent of any damage to the transportation com-

pany and to Vertex Standard.

2.2 Transferring Equipment from Shipping Container to Rack or Cabinet

The repeater is shipped in a box. Upon delivery, the equipment must be removed from the container

and transferred to a rack or cabinet.

NOTE: Customer-supplied cabinets and racks must have mounting rail and hole spacing compat-

ible with EIA Universal 48.3 cm (19 inches) specications. Cabinets must provide adequate

ventilation (see “Environmental Conditions at Intended Installation Site” on page 4) and

must meet the following minimum criteria:

- 41.3 cm (16.25 inches) deep

- 48.3 cm (19 inches) wide

- 13.4 cm (5.25 inches) high

- Two mounting rails 5 cm (2 inches) from the front of the cabinet with front mounting

holes 5.7 cm (2.25 inches) apart (center to center).

Contact Vertex Standard Technical Support for specic question(s) regarding mounting equipment

in customer-supplied cabinets.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Sin comentarios

Vertex Standardt VXD Series Guía de instalación Pagina 13